LiDAR Coverage and Safe Speed
Where can this robot's LiDAR not see, and how fast can it go?
Side view, looking across the robot
Every LiDAR at this mount
Method
beam elevation (forward) = sensor elevation − tilt floor seen from = h / tan(|lowest beam|), and never closer than the minimum range stopping distance s = v·t + v² / (2a) + margin obstacle (height H, width W) at distance d is seen when a beam lies between atan((g − h) / d) and atan((H − h) / d) g = ground filter min range ≤ d ≤ max range d · horizontal resolution ≤ W (spinning and 2D scanners only) smallest obstacle at s = h + s · tan(lowest beam that is still above g at s) top safe speed = a · (−t + √(t² + 2(D − margin) / a)), D = farthest d where the obstacle is seen
Spinning LiDARs are drawn as evenly spaced rings between their quoted limits. Makers that publish uneven ring spacing (denser near the horizon) do slightly better near the horizon than drawn here. Non-repetitive scanners (Livox, Unitree 4D) fill their field over time, so they are treated as a continuous field. Range is quoted at the reflectivity in each source; dark targets come back shorter.
Sources
FAQ
- Why can a robot LiDAR not see the floor right next to the robot?
- The lowest beam leaves the sensor at a fixed angle below horizontal, so it reaches the floor at mount height divided by the tangent of that angle. Anything lower than the beam and closer than that point is invisible. Tilting the sensor down or mounting it lower pulls the point in.
- How is the stopping distance worked out?
- Speed times reaction time, plus speed squared over twice the deceleration, plus a margin that covers the distance from the sensor to the robot's front edge. Reaction time covers one LiDAR frame, perception and the control loop.
- How is the top safe speed found?
- The tool finds the farthest distance at which an obstacle of the chosen height and width is still hit by a beam, then solves the stopping distance equation for the speed that stops the robot inside it.
- Why does a spinning LiDAR miss small objects far away?
- Its rings are a fixed angle apart. At distance d the gap between rings is about d times that angle in radians, so a 10 cm box falls between 1 degree rings beyond about 5.7 m. Non-repetitive scanners such as Livox and the Unitree 4D LiDARs fill the field over time, so the tool treats them as continuous.
- What is the ground filter?
- Navigation stacks drop points within a few centimetres of the floor so the floor is not read as an obstacle. Anything shorter than the filter height is treated as floor and is never an obstacle.
- Where do the sensor numbers come from?
- Each figure links to the maker's product page or datasheet with the quote it was taken from. Mount heights and braking figures that makers do not publish are labelled as assumptions you can edit.
Everything runs in your browser. Nothing you type is sent anywhere. See also the Robot Interconnect Budget, Frame and Rotation Converter and Robot Platform Hub.